TM 9-2350-287-20-17-28. REMOTE CHEMICAL DETECTOR ALARM TERMINALS REPLACEMENT.This Task Covers:a. Removalb. InstallationInitial Setup:Tools/Test Equipment:Equipment Conditions:l General mechanic’s tool kit (Item 24,l Vehicle parked on level groundAppendix I)(refer to TM 9-2350-287-10).l MASTER switch set to OFFMaterials/Parts:(refer to TM 9-2350-287-10).l Lockwasher (Item 118, Appendix H)l Disconnect battery ground cablesl Nonmetallic washer (2) (Item 208, Appendix H)(para 7-41).a.1.2.3.4.b.1.2.3.4.NOTEThere are two pairs of terminals. Each pair is installed on a vehicle-mounted bracket.Each terminal is removed and installed in the same way. These procedures coveronly one terminal.REMOVALRemove nut (10) and Iockwasher (9) from terminal(1). Discard Iockwasher.Remove cable connector (8) from vehicle-mountedterminal bracket (5).Remove washer (7) and nonmetallic washer (6)from terminal (1). Discard nonmetallic washer.Pull terminal (1) out of terminal bracket (5) alongwith nonmetallic washer (3) and two washers (2and 4). Discard nonmetallic washer.INSTALLATIONInstall terminal (1) on terminal bracket (5) usingtwo washers (2 and 4) and new nonmetallic washer(3).Install nonmetallic washer (6) and washer (7) onterminal (1).Install cable connector (8) on terminal bracket (5).Install nut (10) and new lockwasher (9) on terminal(1).FOLLOW-ON MAINTENANCE:l Connect battery ground cables (para 7-41).7-80
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
