TM 9-2350-287-20-1
7-25. COMBAT OVERRIDE SWITCH ASSEMBLY REPLACEMENT.
This Task Covers:
a. Removal
b. Installation
Initial Setup:
Tools/Test Equipment:
l Lockwasher (2) (Item 196, Appendix H)
l General mechanic’s tool kit (Item 24,
Appendix I)
Equipment Conditions:
l Vehicle parked on level ground (refer to
Materials/Parts:
TM 9-2350-287-10).
l Lockwasher (2) (Item 151, Appendix H)
l MASTER switch set to OFF (refer to
l Lockwasher (Item 160, Appendix H)
TM 9-2350-287-10).
a.
1.
2.
3.
4.
5.
b.
1.
2.
3.
4.
5.
REMOVAL
Remove two screws (12), Iockwashers (13), and
washers (14), ground lead (2), combat override switch
(8), and bracket (1) from crew compartment ceiling,
Discard Iockwashers.
Disconnect connector (4) from combat override switch
(8).
Remove screw (7), Iockwasher (6), washer (5), and
strap (3) from ground lead (2). Discard Iockwasher.
Disconnect ground lead (2) from combat overide switch
(8).
Remove two screws (9), Iockwashers (10), and washers
(11) and combat override switch (8) from bracket (1).
Discard Iockwashers.
INSTALLATION
Install combat override switch (8) on bracket (1) with two washers (11), new Iockwashers (10), and screws
(9).
Connect ground lead (2) to combat override switch (8).
Install ground lead (2) in strap (3) and secure with screw (7), new Iockwasher (6), and washer (5).
Connect connector (4) to combat override switch (8).
install combat override switch (8), bracket (1), and ground lead (2) on crew compartment ceiling with two
screws (12), new Iockwashers (13), and washers (14).
FOLLOW-ON MAINTENANCE:
l None
7-77
