7-23. UPPER REAR DOOR CONTROL SWITCHES AND BRACKET REPLACEMENT

d. INSTALLATION - TM-9-2350-287-20-1_771

FOLLOW-ON MAINTENANCE - TM-9-2350-287-20-1_773

TM-9-2350-287-20-1 Carrier Ammunition Tracked M992A21 (2350-01-352-3021) EIC:AE6 Manual
Page Navigation
744

7-23. UPPER REAR DOOR CONTROL SWITCHES AND BRACKET REPLACEMENT. This Task Covers: a. Removal b. Installation Initial Setup: Tools/Test Equipment: Equipment Conditions: l General mechanic’s tool kit (Item 24, l Vehicle parked on level ground (refer to Appendix I) TM 9-2350-287-10). l MASTER switch set to OFF (refer to Materials/Parts: TM 9-2350-287-10). l Lockwasher (2) (Item 160, Appendix H) l Lower rear door opened (refer to TM 9-2350-287-10). l Lockwasher (2) (Item 196, Appendix H) l Battery ground cables disconnected (para 7-41). a. 1. 2. 3. b. 1. 2. 3. REMOVAL NOTE If you are replacing switch bracket, perform steps 1-3. If you are replacing toggle switch only, perform steps 1 and 2 only. Disconnect electrical connector AAF (3), electrical connector door control toggle switch (2). NOTE 10 (4), and electrical connector AAG (5) from Both upper rear door control switches are replaced the same way. Lower control switch is equipped with switch guard. Remove two screws (10) and Iockwashers (9), switch guard (8), and toggle switch (2) from switch bracket (1). Discard Iockwashers. Remove two screws (6) and Iockwashers (7) and switch bracket (1) from vehicle. Discard Iockwashers. INSTALLATION NOTE If you are replacing switch bracket, perform steps 1-3. If you are replacing toggle switch only, perform steps 2 and 3 only. Install switch bracket (1) on vehicle using two new Iockwashers (7) and two screws (6). Install toggle switch (2) on switch bracket (1) using two new Iockwashers (9) and two screws (10). Connect electrical connector AAG (5), electrical connector 10 (4), and electrical connector AAF (3) to toggle switch (2). 7-74 TM 9-2350-287-20-1

Privacy Statement
Press Release
Contact