2-1. GENERAL

CHAPTER 2 GENERAL MAINTENANCE PROCEDURES

2-5. GENERAL INSPECTION AND REPAIR PROCEDURES

TM-9-2350-287-20-1 Carrier Ammunition Tracked M992A21 (2350-01-352-3021) EIC:AE6 Manual
Page Navigation
32

TM 9-2350-287-20-1 2-1. GENERAL. This chapter describes common tools and equipment; repair parts; special tools, TMDE, and support equipment; general inspection and repair procedures; AFES checkout; servicing and connecting batteries; radiator fan protective screens removal and installation; interconnections; preliminary servicing and adjustment of equipment; reporting unsatisfactory conditions; preoperational servicing and adjustment; service interval; reporting repairs; general PMCS procedures; specific PMCS procedures; preventive maintenance checks and services table; electrical troubleshooting; quick guide to troubleshooting; troubleshooting procedures; general STE/lCE test methods; quick guide to STE/lCE troubleshooting; STE/lCE troubleshooting procedures; work safety; cleaning instructions; inspection instructions; repair instructions; tagging hoses, lines, and tubes; lubrication instructions; torque values; decal replacement; definition of administrative storage; preparation for administrative storage; care of equipment in administrative storage; exercise schedule; removal from administrative storage; and preparation of equipment for shipment. 2-2. COMMON TOOLS AND EQUIPMENT. Common tools and equipment are issued to Unit maintenance personnel for maintaining the M992A1. Common tools and equipment should not be used for purposes other than those prescribed and should be properly stored when not in use. For authorized common tools and equipment, refer to the Modified Table of Organization and Equipment (MTOE), CTA 50-970, or CTA 8-100 as applicable to your unit. 2-3. REPAIR PARTS. Repair parts are listed and illustrated in the Repair Parts and Special Tools List (RPSTL), TM 9-2350-287-24P, which covers Unit, Direct Support, and General Support maintenance for the M992A1. Gaskets, packings, preformed packings, seals, Iockwashers, self-locking nuts, cotter pins, and spring pins must be replaced. Bushings must be replaced only if removed. Springs must be replaced if broken, kinked, or cracked or if they do not conform to standards specified in the repair procedures. 2-4. SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT. Special tools, TMDE, and support equipment necessary to perform the maintenance described in this manual are listed in Appendix B for information only. The authority for requisitioning replacements for special tools, TM DE, and support equipment is TM 9-2350-287-24P. 2-2

Privacy Statement
Press Release
Contact