TM 9-2350-287-20-1
3-2. POWERPACK REPLACEMENT (continued).
b.
INSTALLATION
1.
Position engine exhaust pipe (88) and lower fuel
tank return-from-engine hose (4) against hull.
2.
Attach powerpack lifting sling to four powerpack lifting eyes (86) and hoist, and take up slack.
WARNING
·Personnel must stand clear during lifting operations. A swinging or shifting load
can cause severe injury to personnel.
·Do not walk under powerpack while it is being installed in vehicle. Failure to follow
this warning may result in severe injury or death.
CAUTION
·When installing powerpack, be careful of hoses, fittings, and linkages on driver's
compartment wall. Failure to heed this warning may result in damage to equipment.
·Watch all sides of powerpack while it is being installed. Have one person observe
from driver's compartment through engine compartment access cover to make sure
air intake duct is not forced into fuel tank, damaging intake duct and fuel tank.
NOTE
Make sure two transmission lower
trunnion mount inserts are installed in
trunnion mounts.
3.
Install powerpack (87) in vehicle, making sure
lower trunnion mount insert alignment ring (90) in
right transmission trunnion mount (89) seats
properly in powerpack (87).
4.
Remove
powerpac k
lifting
sling
from
four
powerpack lifting eyes (86) and hoist.
Change 1 3-9
