TM 9-2350-287-20-1
3-2. POWERPACK REPLACEMENT (continued).
28.
Remove nine self-locking nuts (83)
and washers (82) and two spacer
plates (81 and 84) and seals (80
and 85) from heat shield (79).
Discard self-locking nuts.
29.
Attach
powerpack
lifting
sling to hoist and four powerpack
lifting eyes (86), and take up slack.
WARNING
·Personnel must stand clear during lifting operations. A swinging or shifting load
can cause severe injury to personnel.
·Do not stand near powerpack while it is being removed from or installed in vehicle.
Failure to heed this warning can result in severe injury or death to personnel.
CAUTION
Lift powerpack carefully. Make sure
all wiring harnesses and mechanical
linkages are secured out of the way.
Failure to heed this warning can result
in damage to equipment.
30.
Raise powerpack (87) several inches and shift it
toward the front of vehicle for clearance. While
lifting powerpack (87) out of vehicle, watch all
sides of powerpack (87) to make sure it clears all
components in hull during removal.
31.
Place powerpack (87) on wooden blocks.
32.
Remove lifting sling from four powerpack lifting
eyes (86) and hoist.
Change 1 3-8
