SIMPLIFIED TEST EQUIPMENT FOR INTERNAL COMBUSTION ENGINES (STE/lCE) (continued)

(2) VTM CONNECTIONS AND CHECKOUT FOR TK

SIMPLIFIED TEST EQUIPMENT FOR INTERNAL COMBUSTION ENGINES (STE/lCE) (continued) - TM-9-2350-287-20-1_440

TM-9-2350-287-20-1 Carrier Ammunition Tracked M992A21 (2350-01-352-3021) EIC:AE6 Manual
Page Navigation
416

TM 9-2350-287-20-1 2-22. SIMPLIFIED TEST EQUIPMENT FOR INTERNAL COMBUSTION ENGINES (STE/lCE) (continued). a. STE/lCE PMCS - (continued). (2) VTM CONNECTIONS AND CHECKOUT FOR TK (continued). Continued from Step B If only part of display shows, module may be burned out. Go to TM 9-4910- 571-12&P for replacement. C. 1. Pull VTM power switch to OFF position. 2. Check and clean battery connections and all interconnecting cables. 3. Push VTM power switch to ON position. Does VTM display show “.8.8.8.8” and then change to ‘- -- -“? I Go to step E. D. 1. Pull VTM power switch to OFF position. 2. Disconnect DCA cable W5 from battery and connect to a known good battery. 3. Push VTM power switch to ON position. I Does VTM display show “.8.8.8.8” and then change to “- -- -“? STE/ICE. Verify promblen is solved. Go to TM 9-4910-571-12&P to fault isolate cable W5. If W5 cable IS good, replace 1. Check battery electrolyte level (refer to TM 9- 2350-287-10). 2. Clean battery terminals (refer to TM 9-2350- 287-10). 3. Check battery specific gravity (refer toTM 9-2350- 287-10). 4. If required, charge batteries. 5. Return to step A. Continued to next page 2-387

Privacy Statement
Press Release
Contact