TM 9-2350-287-20-1
2-19. TROUBLESHOOTING CHART (continued).
g. GAGES (continued).
(7) FUEL GAGE FAILS TO INDICATE LEVEL OF
LOWER FUEL TANK. Indicates level of upper
fuel tank properly (continued).
B. 1. Connect harness 12330252 lead 31 ,to fuel
level switch.
2. Install cover to driver’s instrument panel
with six screws.
3. Remove armor plate cover from overcool-
ing system and exhaust system (refer to TM
9-2350-287-10).
4. Remove engine grill.
5. Remove two self-locking nuts from bar.
Discard self-locking nuts.
6. Remove screw, washer, and stiffener from
bar.
7. Remove nut and washer from bar.
8. Remove two nuts and washers from ac-
cess cover.
9. Remove bar, access cover and seal from
heat shield.
10. Loosen nut and position tube out of the
way.
11. Disconnect electrical connector from
transmitter.
12. Remove five screws and washers and
ground lead from transmitter.
13. Disconnect wire 31 from lower fuel tank
transmitter.
14. Install a jumper wire into lead 31. Do not
ground the jumper wire at this time.
15. Turn MASTER switch ON (refer to TM 9-
2350-287-10).
16. Observe fuel gage at driver’s portable
instrument panel.
Continued on next page
2-125
