TM 9-2350-287-10
CONVEYOR CHAIN MAINTENANCE (continued)
4.
Using four new rivet and nail assemblies (5) and rivet gun (4) install new pad(s) (2)
as follows:
Spread rivet gun (4) handles.
a.
b.
C.
d.
e
f.
Repeat steps a through e for each pad hole until all replacement pads are
installed.
Spread rivet gun (4) handles and remove nail.
While holding pad (2) against plate (1) with rivet and nail assembly (4) and rivet
gun (4), repeatedly squeeze rivet gun handles together until rivet pops from
nail.
Place rivet end of nail through hole of pad (2) and plate (1).
Insert rivet and nail assemblies (5) into rivet gun (4) as shown, pointed end first.
Change 1
3-41