OPERATING THE APU (continued) - TM-9-2350-287-10

OPERATING THE APU (continued) - TM-9-2350-287-10_170

TM-9-2350-287-10 Carrier Personnel Full Tracked Armored M113A3 2350-01-219-7577 (EIC AE7) Carrier Command Post Light Tracked M577A3 2350-01-369-6085 (EIC AE7) Manual
Page Navigation
148

TM 9-2350-287-10 OPERATING THE APU (continued) 12. If batteries in supported vehicle activate gages or lights unaided by the APU, charge battery as follows: a. Turn MASTER switch to ON in your vehicle. b. Start the APU (p. 2-118). c. Turn on APU GENerator switch (7). d. Turn MASTER switch to ON in supported vehicle. Batteries will charge. e. Continue to charge batteries until charge indicator in supported vehicle reads well into normal range. CAUTION l Do not attempt to start disabled vehicle with power from APU STARTER/GENERATOR. Doing this can cause damage to APU STARTER/GENERATOR. The APU is for recharging purposes during slaving procedures only. l Be sure APU GENerator switch is off before turning APU FUEL SHUT OFF switch to OFF. 13. Turn APU FUEL SHUT OFF switch (6) to OFF. 14. 15. WARNING To avoid injury, turn off MASTER switches in both vehicles before disconnecting slave cable. Turn MASTER vehicle. Disconnect and switch to OFF in each stow slave cable. 2-130

Privacy Statement
Press Release
Contact