Charging Low Batteries with the APU

OPERATING THE APU (continued) - TM-9-2350-287-10_165

OPERATING THE APU (continued) - TM-9-2350-287-10_167

TM-9-2350-287-10 Carrier Personnel Full Tracked Armored M113A3 2350-01-219-7577 (EIC AE7) Carrier Command Post Light Tracked M577A3 2350-01-369-6085 (EIC AE7) Manual
Page Navigation
143

OPERATING THE APU (continued) Charging Low Batteries with the APU TM 9-2350-287-10 2. 3. NOTE This procedure applies only to vehicles with low-charge batteries. If no gages or lights function on a vehicle when its MASTER switch is ON, batteries are dead. To charge dead batteries, refer to Charging Dead Batteries with the APU (p. 2-127). Before trying to charge batteries, do the following: a. Check batteries for broken cases or cables, severe corrosion, and other damage. Notify Unit maintenance if batteries are damaged. b. Check electrolyte level (refer to TM 9-6140-200-14). Add distilled water as necessary. FILL TO BOTTOM OF RING Park your vehicle close enough to supported vehicle so that slave cable can be interconnected at slave receptacles of both vehicles. With brake pedal (3) depressed, place shift lever (1) in N (neutral) and set BRAKE LOCK handle (2). To avoid personal injury and vehicle damage, turn off MASTER switch and all other electrical switches in both vehicles. WARNING 2-125

Privacy Statement
Press Release
Contact