TM 9-2350-287-10
STARTING MAIN ENGINE (continued)
NOTE
* Use the following procedure for starting engine in normal temperature climates
(+40F, or 4.4°C). Refer to cold-weather starting procedures (p. 2-212) when
temperature is below +40F (4.40C), or if engine will not start in moderately cold
climates.
* Before applying the service brake while on steep slopes (greater than 20
percent), adjust the driver's seat so you can apply maximum leverage to the
brake.
5. Set vehicle brake by pressing on service brake pedal (15) and pulling out and down on parking BRAKE LOCK handle
(13). Brake will be set when handle is released in this position. If stopping on a steep slope, press on service brake pedal
(15), pull out and down on parking BRAKE LOCK handle (13), release, and press on service brake pedal (15) again.
6. Shift transmission selector lever (14) to N (neutral), and make sure it locks into position.
2-84
