TM 9-2350-277-34
REPAIR DRIVER’S HATCH COVER HINGES (ALL EXCEPT M901A3 AND M981A3) —
Continued
0060 00
INSTALLATION
1.
Clamp or tack weld new hinge (1), (2), or (3) on hatch cover (4). Check alignment of cover hinges with hinges on hull.
2.
Insert spring shield (5) through hinges (3) or (2). Seat shield in hinge (1).
3.
Make sure hinges are aligned and spaced as shown.
4.
Weld hinge (1), (2), or (3) to hatch cover (4). See TM 9-237. Use electrode type 5356.
5.
Clean the weld area and apply touch-up paint to repaired area. See TM 43-0139.
FOLLOW-THROUGH STEPS
1.
Install driver’s hatch cover (see your -20).
END OF TASK
0060 00-3/4 blank
