TM 9-2350-277-34
REPLACE ENGINE — Continued
0015 00
NOTE
There are two sets of index splines located on the engine flywheel and transmission drive
coupling, 180 degrees apart.
Transmission drive coupling may be rotated with a screw driver to align index splines for
assembly. Do not use fingers.
5.
Rotate transmission drive coupling (10) to align with engine flywheel indexing spline (11).
6.
Using engine and transmission stand, adjust transmission to align with engine. With proper alignment, mate engine to
transmission.
NOTE
Do not torque engine to transmission attaching screws and nuts until all twelve screws have
been seated.
7.
Install washer (1) and new locknut (2). TORQUE LOCKNUT TO 25-27 LB-FT (34-37 N m).
8.
Install screw (3), two washers (4), and new locknut (5). TORQUE LOCKNUT TO 25-27 LB-FT (34-37 N m).
0015 00-22
