TM 9-2350-277-20-6
REMOVE/INSTALL NBC CABLE ASSEMBLY (M58 ONLY)
0917 00
THIS WORK PACKAGE COVERS:
Removal (page 0917 00-1).
Installation (page 0917 00-3).
INITIAL SETUP:
Maintenance Level
Unit
Tools and Special Tools
General Mechanic’s Tool Kit (WP 0926 00, Item 65)
Materials/Parts
Corrosion preventive compound (WP 0928 00, Item 24)
Lockwasher (3)
Personnel Required
Unit Mechanic
References
See your -10
Equipment Condition
Engine stopped (see your -10)
Carrier blocked (see your -10)
Ramp lowered (see your -10)
REMOVAL
1.
Remove cable assembly lead (1) from switch (2).
2.
Remove three screws (3), lockwashers (4), and clamps (5) securing cable assembly (1) to bulkhead (6). Remove clamps
(5) from cable assembly (1). Discard lockwashers.
3.
Loosen screw (7) on right angle connector (8) on cable assembly (1). Pull slotted end of ground wire (9) out from
screw (7).
0917 00-1
