TM 9-2350-277-20-5
REPLACE M13 NBC HEATERS AND MOUNTS (M577A3 ONLY)
0796 00
THIS WORK PACKAGE COVERS:
Removal (page 0796 00-1).
Installation (page 0796 00-4).
INITIAL SETUP:
Maintenance Level
Unit
Tools and Special Tools
General Mechanic’s Tool Kit (WP 0926 00, Item 65)
Materials/Parts
Locknut (2)
Locknut (4)
Locknut (6)
Locknut (16)
Lockwasher (2)
Lockwasher (4)
Grommet (AR)
Personnel Required
Unit Mechanic
References
See your -10
TM 3-6680-316-10
Equipment Condition
Engine stopped (see your -10)
Carrier blocked (see your -10)
Battery ground leads disconnected (WP 0338 00)
REMOVAL
1.
Disconnect circuit 579C lead (1) from driver’s heater (2).
2.
Loosen two clamps (3) and remove inlet and outlet hoses (4) and (5) from heater (2).
3.
Remove four screws (6), eight washers (7), four locknuts (8), and heater (2) from frame (9). Discard locknuts.
4.
Disconnect circuit 537G lead (10) from commander’s heater (11).
5.
Loosen two clamps (12) and remove inlet and outlet hoses (13) and (14) from commander’s heater (11).
6.
Remove four screws (15), lockwashers (16), and commander’s heater (11) from support (17). Discard locknuts.
0796 00-1
