INSTALLATION - TM-9-2350-277-20-5

REPLACE M3 NBC HEATERS AND CONTROLLERS (M1059A3 ONLY)

TM-9-2350-277-20-5 Carrier Personnel Full Tracked Armored M113A3 2350-01-219-7577 (EIC AE7) Carrier Command Post Light Tracked M577A3 2350-01-369-6085 (EIC AE7) Manual
Page Navigation
645

TM 9-2350-277-20-5 REPLACE M13 NBC HEATERS AND MOUNTS (M577A3 ONLY) — Continued 0796 00 12. If support (1) was removed, install support on forward bulkhead with two screws (2) and new lockwashers (3). 13. Install commander’s heater (4) on support (1) with four screws (5) and new lockwashers (6). 14. Install inlet and outlet hoses (7) and (8) and two clamps (9) on commander’s heater (4). Tighten clamps. 15. Install circuit 537G lead (10) on commander’s heater (4). 16. Install driver’s heater (11) on frame (12). Secure with four screws (13), eight washers (14), and four new locknuts (15). 17. Install inlet and outlet hoses (16) and (17) and two clamps (18) on driver’s heater (11). Tighten clamps. 18. Install circuit 579C lead (19) on driver’s heater (11). FOLLOW-THROUGH STEPS 1. Connect battery ground leads (WP 0338 00). 2. Start engine (see your -10). 3. Raise and lock ramp (see your -10). 4. Stop engine (see your -10). 5. Check air flow of NBC system. Follow procedures of TM 3-6680-316-10. END OF TASK 0796 00-6

Privacy Statement
Press Release
Contact