INSTALLATION - TM-9-2350-277-20-5

REPLACE COOLANT HEATER FUEL SHUTOFF VALVE - TM-9-2350-277-20-5_399

TM-9-2350-277-20-5 Carrier Personnel Full Tracked Armored M113A3 2350-01-219-7577 (EIC AE7) Carrier Command Post Light Tracked M577A3 2350-01-369-6085 (EIC AE7) Manual
Page Navigation
322

TM 9-2350-277-20-5 REPLACE BATTERY DRAWER INSULATION AND HEAT EXCHANGER (M1064A3 ONLY) — Continued 0719 00 3. If removed, install left insulation sheet (4) right insulation sheet (5), rear insulation sheet (6), bottom insulation sheet (7), and top insulation sheet (8) in battery drawer shield (9). 4. Place two clamps (10) on heat exchanger (11). Install heat exchanger in battery drawer (3). 5. Install battery drawer (WP 0353 00). 6. Place two clamps (12) on two elbows (13). Install two hoses (14) on two elbows (13) and heat exchanger (11). Secure with four clamps (10) and (12). 7. Place two brackets (15) on battery drawer (3). Secure with four screws (16), washers (17), and nuts (18). FOLLOW-THROUGH STEPS 1. Install batteries (WP 0349 00). 2. Fill carrier cooling system (WP 0227 00). 3. Fill coolant heater system (WP 0710 00). 4. Start coolant heater (see your -10). Check heat exchanger for leaks. Turn heater off. 5. Start engine (see your -10). 6. Raise and lock ramp (see your -10). 7. Stop engine (see your -10). END OF TASK 0719 00-3/4 blank

Privacy Statement
Press Release
Contact