REPLACE BATTERY DRAWER INSULATION AND HEAT EXCHANGER (M1064A3 ONLY)

FOLLOW-THROUGH STEPS - TM-9-2350-277-20-5_394

TM-9-2350-277-20-5 Carrier Personnel Full Tracked Armored M113A3 2350-01-219-7577 (EIC AE7) Carrier Command Post Light Tracked M577A3 2350-01-369-6085 (EIC AE7) Manual
Page Navigation
320

TM 9-2350-277-20-5 REPLACE BATTERY DRAWER INSULATION AND HEAT EXCHANGER (M1064A3 ONLY) 0719 00 THIS WORK PACKAGE COVERS: Removal (page 0719 00-1). Cleaning (page 0719 00-2). Inspection and Repair (page 0719 00-2). Installation (page 0719 00-2). INITIAL SETUP: Maintenance Level Unit Tools and Special Tools General Mechanic’s Tool Kit (WP 0926 00, Item 65) Materials/Parts Sealing compound (WP 0928 00, Item 53) Sodium bicarbonate (WP 0928 00, Item 60) Personnel Required Unit Mechanic References See your -10 Equipment Condition Engine stopped (see your -10) Carrier blocked (see your -10) Ramp lowered (see your -10) Batteries removed (WP 0349 00) Carrier cooling system drained (WP 0227 00) Coolant heater system drained (WP 0710 00) REMOVAL 1. Remove four nuts (1), washers (2), screws (3), and two brackets (4) from battery drawer (5). 2. Loosen four clamps (6). Remove two hoses (7) from heat exchanger (8) and two elbows (9). Remove clamps from hoses. 3. Remove battery drawer (WP 0353 00). 4. Remove heat exchanger (8) from battery drawer (5). 5. If damaged, remove top insulation sheet (10), bottom insulation sheet (11), rear insulation sheet (12), right insulation sheet (13), and left insulation sheet (14) from battery drawer shield (15). 0719 00-1

Privacy Statement
Press Release
Contact