REPLACE TENT AND FRAME MOUNTS (M577A3 ONLY)

TM-9-2350-277-20-5 Carrier Personnel Full Tracked Armored M113A3 2350-01-219-7577 (EIC AE7) Carrier Command Post Light Tracked M577A3 2350-01-369-6085 (EIC AE7) Manual
Page Navigation
3

TM 9-2350-277-20-5 REPLACE TENT AND FRAME MOUNTS (M577A3 ONLY) 0628 00 THIS WORK PACKAGE COVERS: Removal (page 0628 00-1). Installation (page 0628 00-3). INITIAL SETUP: Maintenance Level Unit Tools and Special Tools General Mechanic’s Tool Kit (WP 0926 00, Item 65) Torque wrench (WP 0926 00, Item 82) Materials/Parts Cotter Pin (2) Locknut (4) Personnel Required Unit Mechanic References See your -10 Equipment Condition Engine stopped (see your -10) Carrier blocked (see your -10) Ramp lowered (see your -10) Tent frame removed from carrier (see your -10) REMOVAL 1. Remove two locknuts (1), eight washers (2), two screws (3), and two end fittings (4) from rear bulkhead lugs. Discard locknuts. 2. Remove four screws (5), washers (6), and two brackets (7) from rear bulkhead. 3. Remove two locknuts (8), washers (9), screws (10), and retainers (11) from brackets (7). Discard locknuts. 4. Remove two cotter pins (12), nuts (13), washers (14), hand screws (15), and clamps (16) from brackets (7). Discard cotter pins. NOTE There are six quick release pins and attaching chains on the frame assembly. Remove quick release pins and chains, as needed. 5. Open both ends of hook (17). Remove hook from bracket on frame (18) and from chain (19). 0628 00-1

Privacy Statement
Press Release
Contact