TM 9-2350-277-20-3
REPLACE TRAILER HARNESS Continued
0375 00
INSTALLATION
1.
If removed, install spring (1) and elbow (2) in ramp.
2.
If removed, install connector (3) in rear bulkhead.
3.
Route leads (4) through new gasket (5), and out through elbow (2).
4.
Install gasket (5), receptacle (6), and cover (7) on ramp. Secure with four screws (8).
5.
Route leads (4) through spring (1) and connector (3).
6.
Install circuit 90 lead (9) between clamp (10) and weldnut on hull. Secure with new lockwasher (11), new lockwasher
(12), and screw (13).
7.
Install shell connectors on leads (4) (WP 0382 00).
8.
Connect leads (4) to leads (14).
FOLLOW-THROUGH STEPS
1.
Install rear floor plates (WP 0539 00), (WP 0540 00), (WP 0541 00), (WP 0542 00), (WP 0543 00), (WP 0544 00), or
(WP 0545 00).
2.
Connect battery ground strap (WP 0337 00), (WP 0338 00), or (WP 0339 00).
3.
Turn MASTER SWITCH ON (see your -10).
4.
Check with multimeter to make sure harness is installed properly.
5.
Turn MASTER SWITCH OFF (see your -10).
END OF TASK
0375 00-3/4 blank