TM 9-2350-277-20-3
REPAIR BATTERY DRAWER (M1064A3 ONLY) Continued
0353 00
7.
Coat all bearing surfaces of two slide assemblies (1) with grease.
8.
Place two slide assemblies (1) on hull mounts. Extend slide stops. Secure with 10 screws (2), washers (3), and new
locknuts (4).
9.
Extend two slide assemblies (1) to stops. Align two angles (5) with holes in slides. Secure with eight screws (6), washers
(7), and new locknuts (8).
10. Align battery drawer (9) with holes in two angles (5). Secure with eight screws (10), washers (11), and new
locknuts (12).
FOLLOW-THROUGH STEPS
1.
Install batteries and retainers (WP 0349 00).
2.
Install battery leads (WP 0343 00).
3.
Start engine (see your -10).
4.
Raise and lock ramp (see your -10).
5.
Stop engine (see your -10).
END OF TASK
0353 00-5/6 blank