TM 9-2350-277-20-3
REPLACE BATTERY LEADS AND TERMINALS (LEFT SIDE) (M1064A3 ONLY) —
Continued
0343 00
11. Position terminal lug cover (1) and terminal lug (2) on positive battery terminal (3). Secure with screw (4) and nut (5).
12. Install circuit 6P lead (6), circuit 48 lead (7), circuit 6 lead (8), and new grommets (9) in battery compartment.
13. Install circuit 6P lead (6) followed by circuit 48 lead (7) on screw (10) in terminal lug (2).
14. Install circuit 6 lead (8), circuit 778 lead (11), and circuit 772 lead (12) on terminal lug (2). Secure with nut (13).
15. Coat tops of terminal lugs with grease.
16. Close battery drawer (14).
FOLLOW-THROUGH STEPS
1.
Install battery leads (right side) (WP 0344 00).
2.
Install front floor plates (WP 0543 00).
3.
Connect battery ground strap (WP 0337 00).
4.
Turn MASTER SWITCH ON. Check BATT- GEN gage on instrument panel. Gage should read in green or yellow zone
(see your -10).
5.
Start engine (see your -10).
6.
Raise and lock ramp (see your -10).
7.
Stop engine (see your -10).
END OF TASK
0343 00-7/8 blank
