TM 9-2350-277-20-3REPLACE INSTRUMENT PANEL WARNING LIGHTS — Continued 0287 00INSTALLATIONCAUTIONMake sure circuit leads are connected to correct lights. See wiring diagrams at the end of thismanual.1. If removed, install light assembly (1).a. Place light assembly (1) on rear of warning lights panel (2). Secure with two new lockwashers (3) and screws (4).b. Connect circuit lead (5) to light assembly (1).2. Install light bulb (6).a. Install gasket (7) and light bulb (6) in light assembly (1). Push and turn light bulb to the right to secure.b. Install gasket (8) and lens (9) in light assembly (1). Turn lens to the right to secure.FOLLOW-THROUGH STEPS1. Connect battery ground strap (WP 0337 00), (WP 0338 00), or (WP 0339 00).2. Turn MASTER SWITCH to ON (see your -10).3. Check instrument panel warning lights as follows (see your -10):a. TRANS FILTER CLOGGED light should be off.b. Ground circuit 323 lead at back of panel. TRANS FILTER CLOGGED light should be on. Remove ground.c. TRANS OIL LOW PRESS light should be on.d. PARKING BRAKE light should be on when parking brake is on.e. Turn on headlights and depress high beam selector switch (see your -10). HEADLIGHTS HI BEAM light shouldbe on when headlights are on high beam. Turn off headlights.4. Turn MASTER SWITCH to OFF (see your -10).END OF TASK0287 00-3/4 blank
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
