TM 9-2350-277-20-2
REPLACE LEFT/RIGHT TURBO EXHAUST PIPE HEAT SHIELD
0226 00
THIS WORK PACKAGE COVERS:
Removal (page 0226 00-1).
Installation (page 0226 00-3).
INITIAL SETUP:
Maintenance Level
Unit
Tools and Special Tools
General Mechanics Tool Kit (WP 0926 00, Item 65)
Materials/Parts
Nonelectrical wire (WP 0928 00, Item 42)
Personnel Required
Unit Mechanic
References
See your -10
Equipment Condition
Engine stopped (see your -10)
Carrier blocked (see your -10)
Trim vane lowered (see your -10)
Power plant front access door opened (see your -10)
Air cleaner removed if working on right elbow
(WP 0168 00)
Drivers compartment access panel removed if working
on left elbow (see your -10)
REMOVAL
WARNING
Sharp edge safety wire can cut your fingers. Make sure to twist end of wire and bend back close
to the attaching hole.
NOTE
Left and right insulation covers are removed and installed the same way. Left insulation cover
is shown only.
1.
Cut and remove wire (1) connecting capstans (2) on insulation cover (3). Discard wire.
0226 00-1