INSTALLATION - TM-9-2350-277-20-2

REPLACE HAND THROTTLE CONTROL CABLE ASSEMBLY

TM-9-2350-277-20-2 Carrier Personnel Full Tracked Armored M113A3 2350-01-219-7577 Carrier Command Post Light Tracked M577A3 2350-01-369-6085 Manual
Page Navigation
468

TM 9-2350-277-20-2 REPLACE THROTTLE VALVE (TV) MODULATOR AND LEVER — Continued 0218 00 4. Install lever (7) in throttle shaft (8). Secure with screw (9), two washers (10), and new locknut (11). 5. Install nut (12) and anchor (13) on cable (14). 6. Install anchor (13) with cable (14) in lever (7). Secure with washer (15) and new locknut (16). 7. Install nut (17) on cable (14). 8. Tighten jamnut (1) on cable (2) 4-7/16 to 4-9/16 inch (11.27 to 11.58 cm) from bracket (3) to end of shield covering inner cable. 9. Adjust throttle valve modulator (WP 0213 00). FOLLOW-THROUGH STEPS 1. Install exhaust elbow (WP 0221 00). 2. Install air intake elbow (WP 0173 00). 3. Install driver’s power plant access panel (see your -10). 4. Close power plant front access door (see your -10). 5. Lower trim vane (see your -10). END OF TASK 0218 00-5/6 blank

Privacy Statement
Press Release
Contact