TM 9-2350-277-20-2ADJUST ACCELERATOR LINKAGE — Continued 0214 003. Position upper accelerator pedal (1) against heel stop (2). Have helper assist.4. Loosen jamnut (3) on throttle drag link (4).NOTETurn rod end bearing to the left to lengthen throttle drag link, or to the right to shorten linkduring adjustment.5. Turn fuel control shaft (5) to the right until center of connecting pin (6) is 1-1/16 to 1-1/8 inches (27 to 29 mm) frompower plant bulkhead. (H) Hold functional shaft in position.NOTEMake sure free pin fit is made during adjustment.6. Install throttle drag link (4), two washers (7), screw (8), and new locknut (9) on accelerator arm (10). Tighten jamnut (3).0214 00-3
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business