TM 9-2350-277-20-2REPLACE GLOW PLUG HARNESS AND GLOW PLUGS — Continued 0209 00INSTALLATION1. If removed, install two clips (1) on each side of glow plug harness (2).2. Connect glow plug harness (2) to right side (3) of glow plug controller (4).3. Install three glow plugs (5) in left cylinder head (6). TIGHTEN GLOW PLUGS TO 132-156 LB-IN (15-18 N m)TORQUE.CAUTIONGlow plug harness leads are identified with location as to right or left bank. Correct installationof wires is necessary for proper diagnostics to aid in locating a failed glow plug.4. Connect three plug ends (7) of glow plug harness (2) to glow plugs (5) in left cylinder head (6).5. Secure glow plug harness (2) to two brackets (8) on left side cylinder (6) with two clips (1), bolts (9), and nuts (10).TORQUE BOLTS TO 360-420 LB-IN (41-47 N m).6. Repeat Steps 2 - 5 for opposite side.FOLLOW-THROUGH STEPS1. Connect battery ground strap (WP 0337 00), (WP 0338 00), or (WP 0339 00).2. Install rear power plant access panel (see your -10).END OF TASK0209 00-3/4 blank
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business