INSTALLATION - TM-9-2350-277-20-2

REPLACE EXHAUST EVACUATOR VALVE AND CONNECTOR

FOLLOW-THROUGH STEPS - TM-9-2350-277-20-2_301

TM-9-2350-277-20-2 Carrier Personnel Full Tracked Armored M113A3 2350-01-219-7577 Carrier Command Post Light Tracked M577A3 2350-01-369-6085 Manual
Page Navigation
256

TM 9-2350-277-20-2 REPLACE EXHAUST EVACUATOR VALVE AND CONNECTOR — Continued 0175 00 5. Move air cleaner against power plant. Remove connector (13) and valve (10) from muffler (14). Separate connector and valve. Remove clamps (8) and hose (9) from valve. INSTALLATION 1. Join valve (1) and connector (2). Install hose (3) on valve (1). Install clamps (4) and valve (1). 2. Move air cleaner (5) against power plant. Install connector (2) and valve (1) on muffler (6). NOTE The position of the lettering may be within ± 1.5 inch (3.81 cm) of the top. 3. Rotate valve (1) and connector (2) until the lettering is on the top and the drain is on the bottom. 4. Secure connector (2) to muffler (6) and valve (1) with two new clamps (7). 0175 00-2

Privacy Statement
Press Release
Contact