TM 9-2350-277-20-2
REPLACE EXHAUST EVACUATOR VALVE AND CONNECTOR
0175 00
THIS WORK PACKAGE COVERS:
Removal (page 0175 00-1).
Installation (page 0175 00-2).
INITIAL SETUP:
Maintenance Level
Unit
Tools and Special Tools
General mechanic’s tool kit (WP 0926 00, Item 65)
Torque wrench (WP 0926 00, Item 85)
Materials/Parts
Clamp (2)
Lockwasher (2)
Personnel Required
Unit Mechanic
References
See your -10
Equipment Condition
Engine stopped (see your –10)
Carrier blocked (see your –10)
Trim vane lowered (see your –10)
Power plant access door open (see your –10)
Power plant grill raised (WP 0464 00)
REMOVAL
1.
Remove three screws (1) and washers (2) holding air cleaner support (3) to sponson.
2.
Remove two screws (4), lockwashers (5), washers (6), and air cleaner support (7). Discard lockwashers.
3.
Loosen two clamps (8) securing hose (9) to evacuator valve (10) and air cleaner adapter (11). Slide hose (9) onto
evacuator (10).
4.
Remove two clamps (12) securing connector (13) to muffler (14) and evacuator valve (10). Discard clamps.
0175 00-1
