POWER CONTROL ENCLOSURE A1 DC INPUT/OUTPUT INOPERATIVE (M1068A3 ONLY)Continued

POWER CONTROL ENCLOSURE A1 DC INPUT/OUTPUT INOPERATIVE (M1068A3 ONLY)Continued - TM-9-2350-277-20-1_436

POWER CONTROL ENCLOSURE A1 DC INPUT/OUTPUT INOPERATIVE (M1068A3 ONLY)Continued - TM-9-2350-277-20-1_438

TM-9-2350-277-20-1 Hull Powerpack Drive Controls Tracks Suspension and Associated Components Carrier Ammunition Tracked Manual
Page Navigation
330

TM 9-2350-277-20-1 POWER CONTROL ENCLOSURE A1 DC INPUT/OUTPUT INOPERATIVE (M1068A3 ONLY)—Continued 0090 00 BY 1. Turn all vehicle power OFF (see your -10 and TM 11-7010-256-12&P). 2. Remove ten screws (1) and lockwashers (2), and lower faceplate (3). Discard lockwashers. 3. Set MASTER SWITCH to ON 4. Measure voltage between positive (4) and negative (5) terminals on meter M2 (6). 5. Does multimeter read 22 volts DC or more, and the same as meter M2? YES NO BYN 1. Adjust meter M2 needle to match multimeter reading. 2. If meter cannot be adjusted, replace DC meter M2 (WP 0827 00). 3. Verify no faults found. 0090 00-11

Privacy Statement
Press Release
Contact