TM 9-2350-277-20-1
TRANSMISSION DOES NOT HOLD 3RD POSITION
0069 00
INITIAL SETUP:
Maintenance Level
Unit
Tools and Special Tools
General Mechanic’s Tool Kit (WP 0926 00, Item 65)
Multimeter (WP 0926 00, Item 30)
Electrical Connector Pliers (WP 0926 00, Item 31)
Personnel Required
Unit Mechanic
References
See your -10
Equipment Condition
Engine stopped (see your -10)
Carrier blocked (see your -10)
Transmission in 1-3 position
Trim vane lowered (see your -10)
Power plant access door open (see your -10)
T
1. Remove harness 12349810 plug (1) from transmission jack (2).
2. Turn MASTER SWITCH to ON.
3. Measure voltage between each socket on harness 12349810 plug
(1) and ground. Multimeter should read 0 volts at socket B (3), D
(4), and H (5), and at least 18 volts for all remaining socket
checks.
4. Does multimeter read more than 0 volts at sockets B (3), D (4),
and H (5), or less than 18 volts at all remaining sockets?
YES
NO
TN
1. Faulty transmission. Beyond unit
maintenance repair.
2. Notify supervisor.
0069 00-1
