TM 9-2350-277-20-1
TRANSMISSION DOES NOT HOLD 2ND POSITION
0068 00
INITIAL SETUP:
Maintenance Level
Unit
Tools and Special Tools
General Mechanics Tool Kit (WP 0926 00, Item 65)
Multimeter (WP 0926 00, Item 30)
Electrical Connector Pliers (WP 0926 00, Item 31)
Personnel Required
Unit Mechanic
Helper (H)
References
See your -10
Equipment Condition
Engine stopped (see your -10)
Carrier blocked (see your -10)
Transmission in 1-2 position
Trim vane lowered (see your -10)
Power plant access door open (see your -10)
T
1. Remove harness 12349810 plug (1) from transmission jack (2).
2. Turn MASTER SWITCH to ON.
3. Measure voltage between each socket on harness 12349810 plug
(1) and ground. Multimeter should read 18 volts or more at
socket A (3), C (4), E (5), and G (6), and read 0 volts for all
remaining sockets.
4. Does multimeter read less than 18 volts at sockets A (3), C (4), E
(5), and G (6), or more than 0 volts at all remaining sockets?
YES
NO
TN
1. Faulty transmission. Beyond unit
maintenance repair.
2. Notify supervisor.
0068 00-1