HIGH BEAM INDICATOR LIGHT DOESNT WORK

FUEL LEVEL INDICATOR MALFUNCTIONSContinued - TM-9-2350-277-20-1_261

HIGH BEAM INDICATOR LIGHT DOESNT WORKContinued - TM-9-2350-277-20-1_264

TM-9-2350-277-20-1 Hull Powerpack Drive Controls Tracks Suspension and Associated Components Carrier Ammunition Tracked Manual
Page Navigation
182

TM 9-2350-277-20-1 HIGH BEAM INDICATOR LIGHT DOESN’T WORK 0050 00 INITIAL SETUP: Maintenance Level Unit Tools and Special Tools General Mechanic’s Tool Kit (WP 0926 00, Item 65) Multimeter (WP 0926 00, Item 30) Jumper Wire Personnel Required Unit Mechanic Helper (H) References See your -10 Equipment Condition Engine stopped (see your -10) Carrier blocked (see your -10) T 1. Check service and IR headlights (see your -10). 2. Do all lights work properly? YES NO TN 1. Go to Service and/or IR Headlights Don’t Work (WP 0031 00, WP 0032 00). 2. Verify no faults found. Y 1. Remove headlight high beam indicator light cover lens (1) and gasket (2). 2. Remove high beam indicator bulb (3) and gasket (4). 3. Measure resistance between light assembly (5) center contact and ground. 4. Does multimeter read 0 ohms? YES NO YN 1. Replace light assembly (WP 0287 00). 2. Verify no faults found. 0050 00-1

Privacy Statement
Press Release
Contact