AFES ELECTRICAL WIRING HARNESSES (12351498, 12351499, 12351500, AND 12351501 ON VEHICLES 1 THRU 344 OR 12352315, 12352316, 12352353, AND 12352354 ON VEHICLES 345 AND ABOVE) HEPAIR (CONTINUED)

CHAPTER 15 MAINTENANCE PROCEDURES: AUTOMATIC FIRE EXTINGUISHER SYSTEM (AFES)

CHAPTER 16 MAINTENANCE PROCEDURES NBC SYSTEMS

TM-9-2350-267-34 Hull Powerpack Drive Controls Tracks Suspension and Associated Components Carrier Ammunition Tracked Manual
Page Navigation
284

15-2 Change 4 TM 9-2350-267-34 D Remove pin from wire. G Position pin at desired cavity in rest of connnetor face. E Prepare wire and crimp pin, using contact pin crimping tool on wire. AFES ELECTRICAL WIRING HARNESSES (12351498, 12351499, 12351500, AND 12351501 ON VEHICLES 1 THRU 344 OR 12352315, 12352316, 12352353, AND 12352354 ON VEHICLES 345 AND ABOVE) HEPAIR (CONTINUED) H Push pin straight into cavity slowly until tool bit should is flush with rear F Lay pin and wire into semicircular groove of insertion tool bit as shown in face of connector. figure below. NOTE Position pin so that should of barrel butts against tip of tool bit. Hold pin and wire firmly in place with thumb. I Release wire and pull out insertion tool.

Privacy Statement
Press Release
Contact