HYDRAULIC ACTUATOR REPAIR (CONTINUED)

Section Ill HYDRAULIC ACTUATOR - TM-9-2350-267-34_251

TM-9-2350-267-34 Hull Powerpack Drive Controls Tracks Suspension and Associated Components Carrier Ammunition Tracked Manual
Page Navigation
221

11-18 Change 4 TM 9-2350-267-34 HYDRAULIC ACTUATOR REPAIR (CONTINUED) I L Remove and discard piston T-seal (14) and two retainers (15). l CAUTION When clamping piston rod in vise, make sure piston threads and finished surfaces of rod are not clamped. Damage to red or piston could result. Always use shop cloths to protect clamped parts. NOTE An assistant is required to restrain rod during nut removal. Position rod horizontally and clamp flatted end (16) of piston rod (13) in soft- jawed vise. Ensure threaded portion of rod is protected from damage. Remove nut (17), washer (18), piston head (19), and washer (20) from piston rod (13). Remove and discard two retainers (21) and packing (22). M Place each tie rod in vise. Remove nut (23) from each of four tie rods (2). CAUTION When clamping tie rods in vise, do not clamp threaded portions of rods.

Privacy Statement
Press Release
Contact