cleaning - TM-9-2350-267-34

HYDRAULIC BRAKE REPAIR (CONTINUED) - TM-9-2350-267-34_244

HYDRAULIC CLUTCH REPAIR (CONTINUED) - TM-9-2350-267-34_246

TM-9-2350-267-34 Hull Powerpack Drive Controls Tracks Suspension and Associated Components Carrier Ammunition Tracked Manual
Page Navigation
214

HYDRAULIC CLUTCH REPAIR (CONTINUED) P Remove two snaprings (22) and press out two bearings (23) and spacer (24) from pulley (3). WARNING Dry-cleaning solvent (PD-680) is toxic and flamable. To prevent personal injury when using PD-680, use only in a well Ventilated area. Avoid heating vapors. If you become dizzy get fresh air immediately and seek medical attention. Avoid contact with eyes, skin, and clothing. Use protective goggles, gloves, and Clothing. If contact is retie, immediately flush with water and seek medical attention. The flashpoint for Type I dry-cleaning solvent is 100°F (38°C); for Type II it is 140°F (60°C). Do not use near open flame or excessive heat. Clean inner outer disks with dry-cleaning solvent (item 17, Appx B). INSPECTION A Inspect all parts for defects. B Inspect bearings per TM 9-214. REPAIR Replace defective parts. TM 9-2350-267-34

Privacy Statement
Press Release
Contact