REMOVALTHROTTLE CONTROL AND ACCELERATOR PEDAL: REMOVAL AND INSTALLATION (CONTINUED)ABcDNOTEERemove pedal (13), lever (4) and shaft (14) from bulkhead as anassembly.Throttle control rod is part of hand throttle con-trol assembly.INSTALLATIONRemove cotter pin (1) and pin (2) at end of throttle control rodA(3) at lever (4). Discard cotter pin.Remove screw (5), key washer (6), and hand throttle controlBassembly (7) from driver’s bulkhead.Remove spring (8) at pedal.cRemove two screws (9), two lockwashers (10) and two flatDwashers (11) at support bracket (12). Discard lockwashers.NOTEELift pedal assembly until support bracket clearsmounting bracket and remove from bulkhead.Install pedalassembly.(13), lever (4) and shaft (14) in bulkhead as anInstall support bracket (12) with two screws (9), two newlockwashers (10) and two flat washers (11).Install spring (8).Install hand throttle control assembly (7) at driver’s bulkheadwith key washer (6) and screw (5).Install throttle control rod (3) at lever (4) with pin (2) and newcotter pin (1).ROD ASSEMBLIES: DISASSEMBLYTA3128537-25Change 1TM 9-2350-267-20
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business