7-22.2
Change 2
TM 9-2350-267-20
ACCELERATOR, THROTTLE AND ENGINE CONTROL GOVERNOR: REMOVAL AND INSTALLATION
Equipment Condition:
Powerpack removed (p 3-l).
REMOVAL
A
Remove two cotter pins (l), three flat washers (2), spring (3) and B
Remove bolt (5), flat washer (6), and throttle control lever (7)
rod assembly (4). Discard cotter pins.
at transmission. Replace bolt (5) and flat washer (6).
NOTE
C
Remove cotter pin (8) and two flat washers (9) at engine throt-
tle control lever end of connecting link (10). Discard cotter pin.
• Remove throttle control lever (7) only if
damaged or requiring replacement
D Loosen nut (12) and remove end (13) and nut (12).
• If bolt (5) is lost or damaged, notify support
E
Remove quick-release pin (11), chain, and wire.
maintenance,
I
TA57219
