7-18
Change 1
TM 9-2350-267-20
SERVICE AND PARKING BRAKE LINKAGE: REMOVAL, DISASSEMBLY, ASSEMBLY AND INSTALLATION
I
Equipment Condition:
Vehicle blocked.
Parking brake released.
REMOVAL
A
B
C
Remove screw (1) and lockwasher (2) from bell crank (3). Discard
lockwasher.
Remove two screws (4) and two lockwashers (5) from bracket
(6). Discard lockwashers.
NOTE
Support parking brake linkage by hand.
Remove parking brake linkage assembly (7). Pull bell crank (3)
off bracket spindle (8).
DISASSEMBLY
A
B
C
D
E
F
G
Remove pin (9) and handle (10) from end of rod (11). Discard pin.
Remove mounting bracket (6), two flat washers (12) and spring
(13). Discard spring.
Remove pin (14) and collar (15). Discard pin.
Remove cotter pin (16), two flat washers (17) and spring (18).
Discard cotter pin and spring.
Remove screw (19), lockwasher (20), flat washer (21), bell crank
(3) and rod guide (22). Discard lockwasher.
Remove flat washer (23).
NOTE
Removal of nuts from rods is not necessary.
Loosen two nuts (24). Loosen and unscrew rods (11 and 25) from
nut (26).
TA312840