POWERPACK WIRING HARNESS (12268102)

Section III POWERPACK AND HULL WIRING HARNESSES

REMOVAL - TM-9-2350-267-20_645

TM-9-2350-267-20 Carrier Ammunition Tracked M992 (2350-01-110-4660) Manual
Page Navigation
589

POWERPACK WIRING HARNESS (12268102): REMOVAL, REPAIR AND INSTALLATION (CONTINUED) INITIAL SETUP B Disconnect 12 connectors (6 thru 17). Equipment Conditions Powerpack removed (p 3-1). A Disconnect five connectors (1, 2, 3, 4 and 5). C Remove two screws (18), four flat washers (19) and two nuts (20) to disconnect two leads (21 and 22) from starter sole- noid (23). D Remove three screws (24) and three clamps (25). E Remove powerpack wiring harness. REPAIR NOTE Remove electrical tape only from section of harness to be repaired. A Remove section of electrical tape from harness. B Isolate and separate wiring harness branches. C Disassemble wiring branch and replace defective wires (p 2-307). INSTALLATION A Install powerpack wiring harness. B Install three clamps (25) and three screws (24). C Connect two leads (21 and 22) to starter solenoid (23) with two screws (18), four flat washers (19) and two nuts (20). D Connect 12 connectors (6 thru 17). E Connect five connectors (1, 2, 3, 4 and 5). TA312806 6-65/(6-66 blank) Change 1 TM 9-2350-267-20 All data an page 6-66 deleted

Privacy Statement
Press Release
Contact