BATTERIES - TM-9-2350-267-20

TM-9-2350-267-20 Carrier Ammunition Tracked M992 (2350-01-110-4660) Manual
Page Navigation
569

BATTERIES: REMOVAL AND INSTALLATION (CONTINUED) REMOVAL A B WARNING When removing batteries, always disconnect ground cables first. Failure to do so may result in personnel injury or death. WARNING Batteries can emit gases that explode. Do not smoke, have open flame, or make sparks around batteries. If the battery is emitting gases, it can explode, causing death or personal injury. WARNING Batteries contain sulfuric acid which can cause severe burns. Avoid contact with skin, eyes, or clothing, and remove all metal or jewelry. If battery electrolyte is spilled, stop its burning effects immediately (ref. FM21- 11). NOTE Remove cables with terminal lugs attached Loosen two nuts (1) and remove two ground cables (2) from battery terminals. Remove two screws (3), two lockwashers (4) and two ground cables (2) from shunt (5). Discard lockwashers. C D E F G Disconnect STE/ICE wire (6). Loosen six nuts (7) and remove four cables (8) from battery terminals. Remove two nuts (9) and two washers (10), and remove two hold-down brackets (11). Lift out batteries (12). Remove eight screws (13), eight lockwashers (14) and two battery trays (15). Discard lockwashers. INSTALLATION A B c D E F G Install eight screws (13), eight new lockwashers (14) and two battery trays (15). Install batteries (12). Install two nuts (9), two washers (10), and two hold-down brackets (11). Install four cables (8) to battery terminals and tighten six nuts (7). Connect STE/ICE wire (6). Install two screws (3), two new lockwashers (4) and two ground cables (2) to shunt (5). Install two ground cables (2) to battery terminals and tighten two nuts (1). 6-44.1/(6-44.2 blank) Change 4 TM 9-2350-267-20

Privacy Statement
Press Release
Contact