CONVEYOR HYDRAULIC HOSES AND FITTINGS: REMOVAL AND INSTALLATION (CONTINUED)
WARNINGS
Make sure all systems are shut down and
MASTER switch is OFF. Hydraulic fluid maybe
HOT.
Do not perform removal procedures until backup
hydraulic gage has been checked visually. Gage
must show 0 psi.
CAUTION
Cap hydraulic lines and ports immediately after
disconnecting lines, to avoid entry of con-
taminants into system.
F
Disconnect hose assemblies (1) from two adapters (18) and
remove from vehicle.
G Remove two adapters (18) from two bushings (19).
H Remove two bushings (19) from elbows (20 and 21).
I
Remove elbows (20 and 21) from hydraulic motor.
INSTALLATION
A Install elbows (20 and 21) in hydraulic motor.
B Install two bushings (19) in elbows (20 and 21).
C Install two adapters (18) in two bushings (19).
REMOVAL
D Connect hose assemblies (1) to two adapters (18).
A Disconnect two hose assemblies (1) from hydraulic control
E Install strap (17) to secure hose assemblies to conveyor
panel (2).
pedestal, with one screw (14), one new lockwasher (15) and one
Remove two screws (3), two lockwashers (4), plate (5) and two
flat washer (16).
B
grommets (6) from crew compartment floor. Discard
F Position two grommets (13) and plates (9 and 12) where hose
lockwashers.
assemblies (1) pass through crew compartment floor. Secure
C Remove two screws (7), two lockwashers (8) and plate (9) from
plate (9) with two screws (7) and two new lockwashers (8).
Secure plate (12) with two screws (10) and two new
crew compartment floor. Discard lockwashers.
lockwashers (11).
D Remove two screws (10), two lockwashers (11), plate (12) and
G Position plate (5) and two grommets (6) where hose assemblies
two grommets (13) from crew compartment floor. Discard
lockwashers.
pass through crew compartment floor and secure plate with
two screws (3) and two new lockwashers (4).
E
Remove one screw (14), one lockwasher (15), one flat washer
(16) and strap (17). Discard lockwasher.
H Instal1 two tube assemblies (1) on hydraulic control panel (2).
TA313167
16-37
Change 1
TM 9-2350-267-20
