AFES MANUAL DISCHARGE SYSTEM: CABLE ADJUSTMENT PROCEDURE

DISASSEMBLY - TM-9-2350-267-20_1367

CREW AUTOMATIC FIRE EXTINGUISHING SYSTEM TEST (VEHICLES 1 THRU 344)

TM-9-2350-267-20 Carrier Ammunition Tracked M992 (2350-01-110-4660) Manual
Page Navigation
1262

Equipment Condition: AFES MANUAL DISCHARGE SYSTEM: CABLE ADJUSTMENT PROCEDURE INITIAL SETUP ADJUSTMENT AFES deactivated (p 14-14.3). Actuator assembly cover removed (p 14-52.20). A B C D E F Remove slack from bottom cable (3) at actuator block (1) actrator assembly (2). Set adjustment nut (4) againstactuator block (1). Turn lockking nut (5) until flush against ajustment nut. Remove slack from middle cable (6). Set adjustment nut (7) for a 1/32-inch gap to actuator block (1). Tighten locking nut (8). Remove slack from top cable (9). Set adjustment nut (10) for a 1/8-inch gap to actuator block (1). Tighten locking nut (11). Remove slack from handle cable (12). Adjust cable length for a 1/4 to 1/2- inch gap between the handle retaining springs (13) and packing nut (14). Secure actuator assembly end of cable to pin (15) by tightening setscrew (16). Cut off exeess handle cable (12) length inside actuator assembly (2) to leave 3/8 to 1/2 inch beyond pin (15). Install fire extinguisher seal (17) through nut (14) and around handle (18). 14-55 Change 4 TM 9-2350-267-20

Privacy Statement
Press Release
Contact