14-60Change 4TM 9-2350-267-20ENGINE AUTOMATIC FlRE EXTINGUISHING SYSTEM (VEHICLES 1 THRU 344) (CONTINUED)FTure MASTER switch ON and observe engine T/A panel lights. Check forfollowing Sequence:.1 Green POWER ON light comes on immediately and stays lit.2 Within 6 seconds, green PASS TEST light comes on.3 PASS TEST light will go out.4 Yellow FAULT light will come on and remain on.GHIJKLMPress LAMP TEST toggle switch down and inspect all four lamps.Replace defective bulbs.Lift fault identifications access cover. If any LED does not light whenLAMP TEST toggle switch is pressed, replace engine T/A panel (p 14-39).WARNINGIf T/A panel POWER ON lamp does not go out whenT/A panel MAINTenanee switch is turned to verticalposition, disconnect battery ground lead. DO NOTCONTINUE TEST. Troubleshoot AFES (p 2-281).Turn engine T/A panel MAINTenance switch to vertical position. Alllights on T/A panel should go out.Connect electrical connectors to engine AFES extinguisher bottleactuators.Turn engine T/A panel MAINTenance switch to horizontal position andobserve panel lights. Sequence will be the same as in step F, exceptyellow FAULT light will not come on. If it does, troubleshoot engine firedetection system (p 2-281).Turn vehicle MASTER switch OFF. Observe engine T/A panel lights.Green POWER ON lamp should remain lit. If not troubleshoot enginefire detection system (p 2-281).Turn engine T/A panel MAINTenanee switch to horizontal position.
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business