LEFT REAR CANISTER COMPARTMENT SHELVES AND SUPPORTS: REMOVAL AND INSTALLATION (CONTINUED)

LEFT REAR CANISTER COMPARTMENT SHELVES AND SUPPORTS: REMOVAL AND INSTALLATION

LEFT REAR CANISTER COMPARTMENT SHELVES AND SUPPORTS: REMOVAL AND INSTALLATION (CONTINUED) - TM-9-2350-267-20_1072

TM-9-2350-267-20 Carrier Ammunition Tracked M992 (2350-01-110-4660) Manual
Page Navigation
987

LEFT REAR CANISTER COMPARTMENT SHELVES AND SUPPORTS: REMOVAL AND INSTALLATION (CONTINUED) Materials/Parts Zinc chromate paste (Item 46, Appx D) Personnel Required Two Equipment Condition: Crew seat removed (p 9-16). Ventilated facepiece hose guard removed (p 14-3). Stacker bar removed (p 12-45). All restraint bars and restraint straps removed (p 11-22.1). WARNING Before conducting any repairs, make sure that pro- pellant charges and any powder pellets are remov- ed from work area. Failure to do so may result in death or injury of personnel. A Disconnect VFP hoses. B Remove two guides (1) from front post (2) and middle and top posts (3 and 4) by removing four screws (5), four flat washers (6), four lockwashers (7) and four nuts (8) from each guide. Discard lockwashers. C Remove two guides (9) from vehicle hull rear by removing four screws (10), four flat washers (11) and four lockwashers(12) from each guide. Discard lockwashers. D Remove top shelf ( 13) by removing four screws (14), four flat washers (15), four lockwashers (16) and four nuts (17). Discard lockwashers. E Remove shelf (18) from isolators (19) by removing eight screws (20), eight flat washers (21), eight lockwashers (22) and eight nuts (23). Discard lockwashers. F Remove shelf (24) from isolators (19) by removing eight screws (25), eight flat washers (26), eight lockwashers (27) and eight nuts (28). Discard lockwashers. G Remove four isolators (19) from front post (2), support (29) and rear post (30) by removing from each, four screws (31), four lockwashers (32) and four flat washers (33). Discard lockwashers. H Remove four isolators (19) from vehicle hull rear by removing four screws (34), four lockwashers (35) and four flat washers (36) from each isolator (19). I Remove angle (37) from hull by removing five screws (38), five lockwashers (39) and five flat washers (40). Discard lockwashers. J Remove angle (41) from shelf (18) by removing two screws (42), two flat washers (43), two lockwashers (44) and two nuts (45). Discard lockwashers. TA313018 11-17 Change 1 TM 9-2350-267-20

Privacy Statement
Press Release
Contact