PROJECTILE RACK STOWAGE BOX GUARD PLATE ASSEMBLY: REMOVAL, DISASSEMBLY, ASSEMBLY AND INSTALLATION
(CONTINUED)
11-2.1
Change 2
DISASSEMBLY
A Remove guard plates (2 and 3) from pivot bars (4) by removing
eight nuts (12), four supports (13), four plates (14), 16 flat
washers (15), and eight screws (16).
B Remove quick-release pin (1) from guard plate (2) and bar (17)
by removing screw (18). Remove other quick-release pin (1) from
guard plate (3) by removing screw (18).
C Remove chain (19) and S-hook (20) from pins (1).
D Remove nut (21) three flat washers (22) bar (17) and screw (23)
from guard plate (2).
ASSEMBLY
A
Install S-hook (20) and chain (19) on each of two quick-release
pins (1).
B
Install quick-release pins (1) on guard plate (3) and on bar (17)
using screw (18) at each place.
c
Install guard plates (2 and 3) on pivot bars (4) using eight screws
(16), two supports (13) two plates (14), eight flat washers (15)
and eight nuts (12).
D Install screw (23), bar (17), three flat washers (22) and nut (21)
on guard plate (2).
TA57471
TM 9-2350-267-20