R E P L A C E I N F R A R E D P O W E R S U P P L Y C A B L E A S S E M B L Y

TM-9-2350-261-34 Carrier Personnel Full Tracked Armored M113A2 2350-01-068-4077 Carrier Command Post Light Tracked M577A2 2350-01-068-4089 Manual
Page Navigation
177

TM 9-2350-261-34 R E P L A C E I N F R A R E D P O W E R S U P P L Y C A B L E A S S E M B L Y D E S C R I P T I O N This task covers: Remove (page 6-9). Install (page 6-10). I N I T I A L S E T U P Tools: References (cent): General Mechanics Tool Kit (Item 35, App B) See your -20 Personnel Required: Equipment Conditions: Track Vehicle Repairer 63H10 Engine stopped/shutdown (see your -10) Carrier blocked (see your -10) References: Battery ground lead disconnected See your -10 (see your-20) R E M O V E W A R N I NG High voltage in the M19 periscope can cause serious injury or death. Voltage could exceed 16,000 volts. To avoid accidents, observe the following 1. 2. Always connect power cable to periscope before turning MASTER SWITCH and infrared (I.R.) POWER switch to ON. Before disconnecting power cable from M19 periscope, always wait at least two minutes after turning infrared (I.R.) POWER switch and MASTER SWITCH OFF. Do not disconnect power cable until image disappears from periscope screen. Never touch end of power cable, or allow it to contact metal surfaces. If circuit 517 lead (1) is in stowed position, disconnect it from the top of power supply assembly (2) and master switch panel dummy connector (3). If circuit 517 lead (1) is in operating position, disconnect it from the top of power supply assembly (2) and bottom of periscope (4). GO TO NEXT PAGE 6-9

Privacy Statement
Press Release
Contact