TM 9-2350-261-20-4
REPLACE CABLE W124 (M1068 ONLY)
THIS WORK PACKAGE COVERS:
Removal (page 0757 00-1).
Installation (page 0757 00-3).
INITIAL SETUP:
Personnel Required
Maintenance Level
Signal Support System Specialist 31U10
Unit
Equipment Condition
Tools and Special Tools
Engine stopped (see your -10)
Electronic Equipment Tool Kit (WP 0780 00, Item 81)
Carrier blocked (see your -10)
Materials/Parts
Battery ground lead disconnected (WP 0294 00)
Locknut (2)
Tie strap (6)
REMOVAL
Disconnect cable W124 plug P1 (1) from Data Panel Assembly A12 jack J3 (2).
1.
2.
Remove two screws (3), locknuts (4), clamps (5), and four washers (6) from APIU rack (7). Discard locknuts.
3.
Remove screw (8), clamp (9), and clamp (10) from weldnut (11).
Remove four screws (12) and clamps (13) from cables (14) and weldnuts (15).
4.
5.
Remove three tie straps (16) from cables (14). Discard tie straps.
6.
Remove three tie straps (17) from cables (14). Discard tie straps.
