TM 9-2350-261-20-4
REPLACE IGNITER -- Continued
0638 00
INSTALLATION
1.
Install new gasket (10) and igniter (9) in heater.
2.
Place resistor strap (8) on igniter (9). Secure with two nuts (7).
3.
Place ground strap (6) and igniter ground lead (5) on coolant heater. Secure with new lockwasher (4) and screw (3).
4.
Place cover plate (2) on end of heater. Turn cover to right and secure with four nuts (1).
FOLLOW-THROUGH STEPS
1.
Connect battery ground lead (WP 0294 00).
2.
Start heater (see your -10). Check that igniter works right. Turn heater off.
3.
Close power plant access door (see your -10).
4.
Raise trim vane (see your -10).
END OF TASK
